Features of Kreg SPS-F125
Hardwood to hardwood 1000 pack
________________________________________________________________________
Similar Products:
________________________________________________________________________
Kreg SPS-F125 Customer Review(s):
Summary: Kreg SPS-F125 1-1/4' #6 Hardwood Screws
Rating: 5 (out of 5)
Comment: I have just built an entire set of kitchen cabinets using hickory, which is very hard in case you haven't worked with it before. I did not have one twist-off or spin-out with these screws. Excellent screws.
.........................................................................................................................................................................
Summary: They do it well
Rating: 5 (out of 5)
Comment: I bought these with the Kreg Pro Pack Pocket Hole Kit. They do the job well. Other sizes are available as well. It is a good idea to stock up on this 1 1/4' size, since they are intended for use in the most popular wood size of 3/4'. That way you get 1/2' bite into the joining wood. These fine threaded screws are made for hardwoods. The point is so sharp that they will go into Red Oak without having to drill a pilot hole. Even though the Kreg jig comes with a drill bit with a tip on it, that bit does not even penetrate the first piece of wood, let alone the joining piece. They depend on the sharpness of these pocket hole screws to make their way through even the hardwoods. The shaft is narrow enough so as to not cause a split.
A coarse thread is available for soft woods as well.
These Kreg screws are well made, and do the job well. Hope this helps.
.........................................................................................................................................................................
Summary: Note differences between washer and pan head
Rating: 4 (out of 5)
Comment: I bought the Kreg pocket hole kit and love it. It comes with a few dozen 1 1/4 screws, and I bought these thinking they are the same. These are the Pan Head, which are nice, but the ones in the kit are washer heads that have more purchase on the bottom of the pocket. The pan heads will sink into the wood, even using walnut and cherry. I have not had one fail yet, but I worry that they sink about 3/16' deeper into the joint than the other screws. Visit the Kreg site to find the whole assortment of screws and plugs.
.........................................................................................................................................................................
|
